PG9303—Battery Replacement
hen it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com app
The DSC PG9303 door/window sensor requires a 3-volt lithium CR2450 Panasonic battery, which can be purchased at your local hardware, mass retailer, or battery store
Step-by-Step Instructions:
1. Locate the sensor with a low battery on either your system panel or in the Alarm.com app
2. Bypass the sensor on your panel
3. Open the cover by inserting a coin into the slot, then twist to remove. If a coin is not available, insert a 4mm flat screwdriver into each slot of the plastic cover, then twist to open each side.
4. Remove and replace the 3-volt lithium CR2450 Panasonic battery.
5. Make sure the area where the batteries are stored is clean and there is no corrosion.
6. Place the cover back on starting with the opposite end from which it was opened. You should hear a snapping sound if it closes correctly.
7. Arm and disarm the system to clear the bypassed sensor.
8. Check if the low battery status has cleared or follow the link below for further instructions on clearing the error from the panel memory:
Related Articles
Vista—Replace Backup Battery
Follow the instructions below to replace the backup battery in your system's panel. The Honeywell Vista panel requires a rechargeable (sealed lead-acid type) 12VDC, 4AH minimum battery pack rated for 24 hours, which can be purchased at your local ...GC2/GC2e—Sensor Malfunction
GC2/GC2e — Sensor Malfunction Your alarm panel performs a “roll call” every hour, sending a signal to all connected sensors to confirm they’re working properly. If a sensor fails to reply, the panel will display a Malfunction/Failure message, and you ...IQ Panel 4—Sensor Malfunction
Every hour, your alarm system sends a signal (called a roll call) to each sensor to confirm it’s working and reporting properly. If a sensor doesn’t respond, the system sends a failure signal to the control panel. You’ll then see an alert or ...PG9303—Resolving a Malfunction
Resolving Errors on a New Device: If this error occurs on a newly installed device, it is usually an indication that the sensor is too far from the panel to maintain a signal. Determine whether you are able to move the sensor closer to the panel, or ...What to Do if the IQ Panel 4 is Not Responding
Important Precautions Before Rebooting Before rebooting your IQ Panel 4, review these notes to avoid unnecessary risks: Try Software Reboot First – If any part of the screen still responds, attempt a software reboot through the settings menu. This is ...