Connecting Alarm.com Wireless bridge to Wireless Network
WPS mode (1st Option)
Complete these steps to connect the W110 to the wireless network using WPS Mode.
1. Plug the W110 into a non-switched electrical outlet that is within close range of the customer’s Wi-Fi network/
router. Wait for the Power LED to begin blinking white.
2. Hold down the Communication button until the Wi-Fi LED turns off and the Communication LED begins blinking
green (approximately 2 to 6 seconds).
3. Activate the WPS Mode on the router. The W110 begins to connect to the wireless network.
4. Allow a few minutes for the W110 to connect. The Wi-Fi LED will turn solid white and the Communication LED will
turn solid camera green when a successful connection is made.
5. Connect the PoE camera to the Camera port at the bottom of the W110 using an Ethernet cable.
AP Mode (Alternative Option)
Complete these steps to connect the W110 to the wireless network using AP Mode
1. Plug the W110 into an electrical outlet that is within close range of the customer’s Wi-Fi network/router. Wait for
the Wi-Fi LED to begin blinking white.
2. On an Internet-enabled device, connect to the wireless network W110 (XX:XX:XX) where XX:XX:XX is the last six
characters of the W110’s MAC address, which is located on the back of the W110 or on the packaging.
3. On the same device, open a web browser and enter http://W110install in the URL field. Follow the on-screen
instructions to add the W110 to the wireless network.
4. Allow a few minutes for the W110 to connect. The Wi-Fi LED will turn solid white, and the Communication LED will
turn solid green when a successful connection is made.
5. Connect the PoE camera to the port at the bottom of the W110 using an Ethernet cable.
Related Articles
Why Does the Hik-connect App Say Network is Unstable?
While using the Hik-connect app to monitor your cameras at your home or business, you may have noticed the “network is unstable” message. This message can be frustrating since it interrupts your live feed. Why does this happen? To keep it simple it ...How to Set Up Motion Detection with Alarm Sound & Flashing Lights (UNV-Link App)
With the UNV-Link app, you can configure your Uniview camera to detect motion and trigger alarms such as custom sounds, flashing lights, and mobile notifications—enhancing your surveillance system's deterrence and responsiveness. ✅ Step-by-Step Setup ...I recently changed internet providers and I cannot view my cameras.
Troubleshooting Camera Viewing After Changing Internet Providers If you've recently changed your internet provider and are no longer able to view your security cameras, follow the steps below to get reconnected. We've broken it down by common ...How to playback on a Hikvision DVR/NVR
The Hikvision NVR/DVR Quick Guide for GUI 4.0 outlines the following steps for setting up and using your system: Navigating the Recorder's Menu: Utilize the mouse to navigate through the menu, confirming selections with a left click. Remember to ...How to: Configure Port Forwarding on a Hikvision Recorder
In this guide, we’ll go through the steps you need to take to allow remote viewing on your Hikvision recorder. Ensure you follow each step carefully and keep a note of various IP addresses etc as you follow the guide. Hikvision has multiple apps on ...